Hood Fitment Information
Hood Fitment Information
Because our hoods are 3D printed and very thin, they can sometimes flatten slightly during shipping or storage. If your hood does not conform properly to the shape of the body, do not force it into place or glue it down flat.
To reshape the hood, gently warm it using one of the following methods:
- Place it in warm water for a short time until it becomes slightly flexible.
- Hold it in front of a space heater or use a hair dryer for approximately 30–40 seconds, just long enough to soften the part slightly.
Once warm, gently bend the hood back to match the contour of the body and hold it in position while it cools.
Do not overheat the part or place it too close to the heat source, as excessive heat can warp or damage it.
This is normal with very thin 3D printed parts and does not mean the hood is defective.
2023–2025 Gen 7 Camaro Full Detail Body Set
2023–2025 Gen 7 Camaro Full Detail Body Set
Couldn't load pickup availability
23/25 Cup Series Gen 7 Chevy Camaro Full Detail body w/Separate Hood, Trunk Lid and Roof Hatch. Includes my custom grill, fuel filler, roof camera, rear camera, and side window brace. Also includes the duct work for the engine. The roof flaps, roof rails, and cowl flaps, are all separate pieces as well. Some sanding will be required especially on the sides. I've cleaned them up a little and some bodies may require more sanding than others in certain areas. ANY next gen kit can be used as a donor with this body and the glass will fit like the other kits. Not sure how the under hood duct work fits, may required some modification to kit parts or printed parts. NOTE - May take longer than 2 weeks to ship out depending on stock and how busy i am. I will do my best!!!!Bodies can be a crap shoot sometimes and take a lot more work than printing parts. Please be patient!!
Share
