Hood Fitment Information
Hood Fitment Information
Because our hoods are 3D printed and very thin, they can sometimes flatten slightly during shipping or storage. If your hood does not conform properly to the shape of the body, do not force it into place or glue it down flat.
To reshape the hood, gently warm it using one of the following methods:
- Place it in warm water for a short time until it becomes slightly flexible.
- Hold it in front of a space heater or use a hair dryer for approximately 30–40 seconds, just long enough to soften the part slightly.
Once warm, gently bend the hood back to match the contour of the body and hold it in position while it cools.
Do not overheat the part or place it too close to the heat source, as excessive heat can warp or damage it.
This is normal with very thin 3D printed parts and does not mean the hood is defective.
Next Gen Full Detail Set
Next Gen Full Detail Set
Couldn't load pickup availability
Next Gen Full Detail Set
Take your 1/24 Next Gen build to the next level with my complete Full Detail Set. This set includes a large selection of highly detailed part needed to fully detail one next gen model kit.
The main product photo shows the complete set laid out together. Certain components will vary depending on the options selected.
Choose Your Options
Wheels
- With molded-in valve stems
- Without molded-in valve stems
Seat Style
- Sabelt Style
- Hendrick Style
Seat Construction
- One-Piece
- Multi-Piece
Manufacturer
- Chevrolet
- Ford
- Toyota
Manufacturer selection determines the correct valve covers, ignition coils, and fuel rail.
Included Components
Suspension & Brakes
- Detailed shocks
- Brake rotors
- Hubs
- Brake calipers and pads
- Front and rear sway bar set
- Choice of wheels with or without molded-in valve stems
- Wheel nuts
Interior & Safety
- Choice of Sabelt Style or Hendrick Style seat
- Choice of one-piece or multi-piece seat construction
- Multi-piece dash set
- Interior electronics set
- Window net
- Upper cage assembly with mirror
- Seat mount
- Side window brace
- Side mirrors
- Fire bottle set
- Roll bar padding
- Shifter
- Radio set
Engine & Fluid Systems
- Manufacturer-specific valve covers
- Manufacturer-specific ignition coils
- Manufacturer-specific fuel rail
- Coolant bottle
- Master cylinder reservoir
- Power steering reservoir
- Fuel pump
- Fuel filler end
Drivetrain & Exhaust
- Headers
- Driveshaft
Cooling, Ducting & Rear Interior
- Package shelf duct work
- Oil tank vent line
- Oil tank
- Koolbox with duct work
Electronics, Data & Cameras
- SMT data module set
- 360 camera set
- SMT antenna
- Radio antenna
- Roof camera
- Rear camera
Some components shown in the main photo may differ depending on the manufacturer and options selected. Only one version of each selectable component is included with the set.
Parts are supplied unfinished and may require normal model-building preparation before assembly and painting.
Designed for SalvinosJR Models (SJR) 1/24 scale Next Gen NASCAR kits.
Share
